The scoring of bowling is not difficult. There are ten grids in each round. There are two balls in each grid. There are ten pins in total. We must try to knock down all the pins within two balls. All the pins are knocked down, that is, “STRIKE”, and an “X” appears on the screen. Even if a square is completed, the score is 10 points plus the number of downed pins for the next square and two balls, but if the first ball is not If the remaining pins are all knocked down, that is, “SPARE”, and “/” appears on the screen, it is considered to complete a grid, and the score is 10 points plus the next grid. The number of downed pins on the first ball, but if the second ball does not knock down all the pins, the score is the first ball plus the number of pins downed by the second ball, and then hit the next grid. And so on until the tenth square. But there are three balls in the tenth square. If the first ball or the second ball knocks down all the pins in the tenth square, you can add a third ball, so that the game is completed, it is not difficult!
To play bowling, you must grasp the correct force:
The force mentioned here is the energy that causes the ball to pass through the wooden bottle with the required deviation on the table, and the well causes the wooden bottle to be knocked down in the perfect order. The action force includes a lot of content. It is the general term for the lifting force of the arm, the rotation of the ball, the finger force and the hook force. Chief among them should be the position of the thumb, ring finger, and middle finger when the ball is released and the force they exert on the ball. The force also tends to be extended to include all other elements of the ball itself when hitting the bottle. So the force is the result of many factors coming together on the ball. Including fairway conditions, ball speed, ball weight, unbalanced weight of the ball, bottle weight and center of gravity of the bottle, foul line angle and shooting angle, etc. The forces created by these factors allow the ball to reach the pocket, impact the bottle and pass through the table. If the force when the ball reaches the pin table is too large, it will not follow the deviation path of the ①-③-⑤-9 pin position after it hits the bottle pocket. On the left side of the vertical pin area, there is a supplementary pin, which indicates that the ball has too much effect.
Hook ball is to add lateral force in the direction of forward rolling, because the damage of the dough is greater. The side spin caused by the lateral force in the hook ball can easily cause the impact effect of the pin being tilted or sideways. The impact effect of the hook ball is greater than that of the straight ball, so the probability of hitting all the shots is quite high. When the angle of incidence reaches 6 degrees, it can hit all the shots. In the hook method, when holding the ball, the line connecting the thumb and middle finger is parallel to the foul line. When throwing the ball, first pull out the thumb, and then pull out the other two fingers. At this time, the fingertips of the middle finger and ring finger should not be too hard. As long as the ball is slightly raised and then pulled out, there will naturally be a hook path.
